Some time ago I figured out the pins of of IV-3A VFD tube. In the upcoming articles series I’m going to build a simple counter, and planning to use some of my LAB equipment to test and build this counter. Just for fun.
Roughly I’m thinking of planning the following articles :
- Implement the PSU for the different voltages (1V,5V,20V)
- Design and implement the display driver
- Use the HP 8175A to simulate a 4 bit binary counter
- Using a Hp8110A as a serial data generator to simulate a 4 bit counter
- Finally build the counter
Implement the PSU for the different voltages (1V,5V,20V)
One of the first challenges when working with a VFD tube is getting all the different voltage rails required. The IV-3A tube needs the a couple of voltages: 1V,5V,20V
The get the 5V rail is not a real problem, 1V and 20V can be more difficult.
To start with the 1V rail, one might think of a simple voltage divider, but this is not as simple as it sounds. When trying to drive the heaters, this will add a load to the voltage diver. Which lowers the voltage, resulting in a voltage which is to low. This could be addressed by adding a opamp, as a buffer. However the circuit is going to get more and more complex.
So in this design I’m going to use small DC-to-DC converters. Or step-up converts to be more precise. And I use two modules:
- One module to step up the voltage to 20v
- One module to down convert the voltage to 1V
The modules ‘m going to use are:
These modules are cheap, and easy to use.
The downside to this is that the heater could be driven “to hard”, on the other hand, these tubes can take somewhat of a “punishment”. I’ll keep the rest of the voltages low by driving the tube with 20V instead of the max 30V.
Both of the DC-to-DC converter modules are driven from a 5V supply. This makes it easy to implement the modules.
In the next article the display driver is going to be implemented.